[Design Description] Full-frame printing, single-sided printing
[Material description] aluminum alloy
[Product performance] It can rotate 360 degrees freely, allowing you to rotate to find the angle you like when driving a car; large disk, large suction, the mobile phone will not fall; carefully selected strong adhesive base, temperature resistant, durable, No trace left; upgrade disks, more stable against bumps, designed for bad road conditions, non-slip rubber inside the turntable, the car can maintain a fixed angle during vibration; take out the metal plate from the phone case or the back of the phone, without disturbing motion sensing, GPS signals or internal sensors will not cause damage to the device or affect the battery.
[Applicable scenarios] Not only for cars, but also for desks, kitchens, bathrooms, and even showers.
[Accessory structure] Car bracket, metal patch (magnet sheet), cleaning towel
[Washing instructions] Just wipe
[Instructions] 1. Clean the back of the phone
2. Attach the mobile phone patch (magnetizing film) to the center of the back film of the mobile phone and press the patch tightly, and then use it after 3 hours
3. Use a No. 1 cleaning cloth to clean the car table, and then use a No. 2 cleaning cloth to clean the table.
4. Peel off the double-sided adhesive protective film of the base, install the base of the bracket on the cleaned surface and press firmly for 20 seconds, then release your hand, and use it after 24 hours to make it completely adhered.
5. The bracket was attached to the magnetizing piece and installed successfully
[Special note] Try to choose the mounting surface of the base with the texture and the arc
Design tips:
A side printing area picture size: 119 * 119 px