[Design Description] Full-frame printing, single-sided printing [Material description] aluminum alloy oxidation + luminous silicone ring [Product performance] 360-degree free rotation; large disk, large suction, the phone will not fall; carefully selected strong adhesive base, temperature resistance, durable, leaving no traces; upgrade disks, more stable against bumps, for bad road conditions Designed with non-slip rubber inside the turntable, the car can maintain a fixed angle during vibration; take out the metal plate from the phone case or the back of the phone, it will not interfere with motion sensing, GPS signals or internal sensors, and will not cause damage to the device or affect the battery . [Applicable scenarios] Not only for cars, but also for desks, kitchens, bathrooms, and even showers. [Accessory structure] bracket, back film, magnet sheet, cleaning towel [Washing instructions] Just wipe [Instructions for use] 1. Wipe the back of the phone clean and stick the back film to the back of the phone
2. Attach the mobile phone patch (magnetizing film) to the center of the back film of the mobile phone and press the patch tightly, and then use it after 3 hours
3. Use a No. 1 cleaning cloth to clean the car table, and then use a No. 2 cleaning cloth to clean the table.
4. Peel off the double-sided adhesive protective film of the base, install the base of the bracket on the cleaned surface and press firmly for 20 seconds, then release your hand, and use it after 24 hours to make it completely adhered.
5. The bracket was attached to the magnetizing piece and installed successfully [Special note] Try to choose the mounting surface of the base with the texture and the arc Design tips:
A side printing area picture size: 119 * 119 px