[Design Description] Full-frame printing, single-sided printing
[Material description] aluminum alloy oxidation + luminous silicone ring
[Product performance] 360-degree free rotation; snap-on type, air outlet in the car, no sticking, silicone cover protects firmly and does not hurt the air outlet; large disk, large suction, mobile phone will not fall; temperature-resistant, durable; upgrade Magnetic disk, more stable against bumps, designed for bad road conditions, non-slip rubber inside the turntable, the car can maintain a fixed angle during vibration; remove the metal plate from the phone case or the back of the phone without disturbing motion sensing, GPS signals or internal sensors , Will not cause damage to the device or affect the battery.
[Scenario] Air outlet in the car
[Accessory structure] Car bracket, magnet plate,
[Washing instructions] Just wipe
[Instructions for use] 1. Wipe the back of the phone clean and stick the back film to the back of the phone
2. Attach the mobile phone patch (magnetizing film) to the center of the back film of the mobile phone and press the patch tightly, and then use it after 3 hours
3. Wipe clean with a cleaning cloth to make the table clean
4. Peel off the double-sided adhesive protective film of the base, install the base of the bracket on the cleaned surface and press firmly for 20 seconds, then release your hand, and use it after 24 hours to make it completely adhered.
5. The bracket was attached to the magnetizing piece and installed successfully
[Special note] Try to choose the mounting surface of the base with the texture and the arc
Design tips:
A side printing area picture size: 119 * 119 px